Filter
Top Products
Chapter 7 Network Setting
WiMAX Device Configuration User’s Guide
103
This screen contains the following fields:
7.10 MAC Address Filter
This screen is available for models with WiFi wireless feature. Use this screen to restrict access to
the WiFi network by device ID (MAC address).
Click on Network Setting > WLAN > MAC Address Filter. The screen appears as shown.
Figure 51 MAC Address Filter Screen
This screen contains the following fields:
Table 33 WPS
LABEL DESCRIPTION
Enable WPS Select Enable and click Apply to activate WPS on the WiMAX Device. Select
Disable and click Apply to deactivate WPS.
Start WPS PBC This field is available after you select Enable in the Enable WPS field and click
Apply.
Click this to activate the Push Button Configuration. After clicking this you will be
able to use the WPS button at the back of the device to add new wireless clients.
Note: You must press the WPS buttons within two minutes of each other.
Table 34 MAC Address Filter
LABEL DESCRIPTION
Enable MAC
Address Filter
Select the check box to enable MAC address filtering. Then, the following fields
display.
Mode Define the filter action for the list of MAC addresses in the MAC address table.
Select Allow listed stations to permit access to the WiMAX Device only to
addresses listed. MAC addresses not listed will be denied access to the WiMAX
Device.
Select Deny listed stations to block access to the WiMAX Device to the
computers or devices listed in this list.
# This is the index number of the MAC address.
Active Select this box to make the policy effective or ineffective for a particular device.
Name Type the name of the device. The name can be up to 20 characters long, and any
combination of letters, numbers or symbols.