Filter
Top Products
Chapter 12 Maintenance
WiMAX Device Configuration User’s Guide
187
12.9 Date/Time
Use these settings to set the system time or configure an NTP server for automatic time
synchronization.
Click Maintenance > Date/Time > Date to open this screen as shown next.
Figure 112 Date Screen
This screen contains the following fields:
12.10 Time Zone
Use this screen to set the time zone in which the WiMAX device is physically located.
Table 88 Date
LABEL DESCRIPTION
Manual
New Time Enter the new time in this field.
New Date Enter the new date in this field.
Get from Time Server
Time Protocol Select the time service protocol that your time server uses.Check with your ISP
or network administrator, or use trial-and-error to find a protocol that works.
• NTP (RFC 1305) - This format is similar to Time (RFC 868).
Time Server
Address 1~4
Enter the IP address or URL of your time server. Check with your ISP or network
administrator if you are unsure of this information.