Filter
Top Products
Chapter 12 Maintenance
WiMAX Device Configuration User’s Guide
183
12.6 SNMP
Use this screen to allow remote access to the WiMAX Device from a network connection over SNMP.
Click Maintenance > Remote MGMT > SNMP to open this screen as shown next.
Figure 109 SNMP Screen
This screen contains the following fields:
12.7 CWMP
Use this screen to allow CWMP connections for remote management, firmware upgrades and
troubleshooting.
Table 85 SNMP
LABEL DESCRIPTION
Enable Select this to enable remote management using this service.
Location Enter the location of the SNMP server (for example, “Engineering Dept., Floor 6,
Building A, New York City”).
Contact Enter contact information for the administrator managing the SNMP server (for
example, “Bill Smith, IT Dept., (555) 555-5454”).
Read Community Enter the password for the incoming Get and GetNext requests from the
management station. The default is public and allows all requests.
Write Community Enter the password for incoming Set requests from the management station.
The default is public and allows all requests.
Trap Server
Enter the IP address of the station to send your SNMP traps to.
Trap Community Enter the trap community, which is the password sent with each trap to the
SNMP manager. The default is public and allows all requests.