Filter
Top Products
Chapter 7 Network Setting
WiMAX Device Configuration User’s Guide
107
7.14 Port Forwarding
Use these settings to forward incoming service requests to the ports on your local network.
Note: Make sure you did not configure a DMZ host in the Network Setting > NAT >
DMZ screen if you want to make the settings of this screen work.
Click Network Setting > NAT > Port Forwarding to open this screen as shown next.
Figure 55 Port Forwarding Screen
This screen contains the following fields:
Authentication Use this option to enable or disable RIP authentication.
Authentication ID Enter the authentication ID to use for RIP authentication.
Authentication
Key
Enter the authentication key to use for RIP authentication.
Table 37 RIP (continued)
LABEL DESCRIPTION
Table 38 Port Forwarding
LABEL DESCRIPTION
Active This indicates whether the port forwarding rule is active or not.
Name The displays the name of the port forwarding rule.
Protocol This displays the protocol to which the port forwarding rule applies.
Incoming Port(s)
Start Port This displays the starting port number for incoming traffic for the port forwarding
rule.
End Port This displays the ending port number for incoming traffic for the port forwarding
rule.
Forward Port(s)
Start Port
This field displays the beginning of the range of port numbers forwarded by this
rule.
End Port
This field displays the end of the range of port numbers forwarded by this rule. If
it is the same as the Start Port, only one port number is forwarded.
Server IP This displays the IP address of the server to which packet for the selected port(s)
are forwarded.
Delete Click this to delete a specified rule.
Wizard Click this to open the port forwarding “wizard”.
Add Click this to add a new port forwarding rule.
OK Click this to save any changes made to the port forwarding list.