Filter
Top Products
Chapter 7 Network Setting
WiMAX Device Configuration User’s Guide
99
7.7 DHCP
Use these settings to configure whether the WiMAX Device functions as a DHCP server for your local
network, or a DHCP relay between the local network and the service provider. You can also disable
the DHCP functions.
Click Network Setting > LAN > DHCP to open this screen as shown next.
Figure 48 DHCP Screen
This screen contains the following fields:
Table 31 DHCP
LABEL DESCRIPTION
DHCP Server
DHCP Mode Select this if you want the WiMAX Device to be the DHCP server on the LAN. As a
DHCP server, the WiMAX Device assigns IP addresses to DHCP clients on the LAN
and provides the subnet mask and DNS server information.
• None - This disables DHCP mode for the WiMAX Device.
• Server - This sets the WiMAX Device as a DHCP server for the LAN.
• Relay - This sets the WiMAX Device as a DHCP relay for the LAN, allowing it
to pass-through IP addresses assigned to LAN devices from the ISP servers.
Start IP Enter the start IP address from which the WiMAX Device begins allocating IP
addresses.
End IP Enter the end IP address at which the WiMAX Device ceases allocating IP
addresses.