Filter
Top Products
Chapter 7 Network Setting
WiMAX Device Configuration User’s Guide
120
Click Network Setting > VLAN to open the screen as shown next.
Figure 64 VLAN Screen
This screen contains the following fields:
Table 46 VLAN
LABEL DESCRIPTION
VLAN Utility
Enable VLAN Select Yes to enable the VLAN function on the WiMAX Device.
Note: To use VLAN on the WiMAX Device, you must switch the operation mode to
“bridge” on the Network Setting > WAN screen. It will then require system
restart to take effect.
Port Settings
# This is the index number of the port setting.
Interface This displays the interface that the port setting applies to.
Link Type Select Access if this port forwards traffic for only one VLAN. The device
connected to an access port does not support VLAN tagged packets, so the
WiMAX Device will remove packets forwarded out of this port. Packets received
on access ports will be tagged with the specified PVID.
Select Trunk to allow packets belonging to different VLAN groups to pass
through the port. The device connected to this port should support VLAN tagged
packets. You must configure Filter Settings for the port and VLAN ID for tagged
packets to be forwarded. If received packets are already tagged, the PVID set for
this port should not be the same as the VLAN IDs configured in Filter Settings.
This will allow the tagged packets to be forwarded to the specified VLANs. If
received packets are not tagged, the WiMAX Device will tag them with the PVID.
Select Hybrid to allow the port to function as an access port and trunk port.
PVID A PVID (Port VLAN ID) is a tag that adds to incoming untagged packets received
on a port so that the packets are forwarded to the VLAN group that the tag
defines. Enter a number between 1and 4094 as the port VLAN ID.