Filter
Top Products
Chapter 3 Setup Wizard
WiMAX Device Configuration User’s Guide
28
The following table describes the labels in this screen.
3.1.4 WiMAX Authentication Settings
The WiMAX Authentication Settings screen allows you to configure how your WiMAX Device logs
into the service provider’s network.
Note: These settings should be provided by your ISP.
Note: The EAP supplicant settings on this screen vary depending on the authentication
mode your select.
Table 6 Setup Wizard > WiMAX Frequency Settings
LABEL DESCRIPTION
Setting Type Select the WiMAX frequency setting type from the list.
• By Range - Select this to set up the frequency based on a range of
MHz.
• By List - Select this to set up the frequency on an individual MHz basis.
You can add multiple MHz values to the list.
Step Enter the increments in MHz by which to increase the frequency range.
Note: This field only appears when you select By Range under Setting Type.
Start Frequency Enter the frequency value at the beginning of the frequency range to use.
The frequency is increased in increments equal to the Step value until the
End Frequency is reached, at which time the cycle starts over with the
Start Frequency.
Note: This field only appears when you select By Range under Setting Type.
End Frequency Enter the frequency value at the end of the frequency range to use.
Note: This field only appears when you select By Range under Setting Type.
Bandwidth Set the frequency bandwidth in MHz that this WiMAX Device uses.
# This is an index number for enumeration purposes only.
Frequency (MHz) Displays the frequency MHz for the item in the list.
Total Num Displays the total number of items in the list.
Delete Click this to remove an item from the list.
Add Click this to add an item to the list.
OK Click this to save an newly added item to the list.
# This is an index number for enumeration purposes only.
Band Start (KHz) Indicates the beginning of the frequency band in KHz.
Band End (KHz) Indicates the end of the frequency band in KHz.
Total Num Displays the total number of items in the list.
Back Click to display the previous screen.
Next Click to proceed to the next screen.