Filter
Top Products
Chapter 12 Maintenance
WiMAX Device Configuration User’s Guide
191
Click Maintenance > Backup/Restore > Restore to open this screen as shown next.
Figure 118 Restore Screen
This screen contains the following fields:
12.15.1 The Restore Configuration Process
When the WiMAX Device restores a configuration file, the device automatically restarts. This causes
a temporary network disconnect.
Note: Do not turn off the device while configuration file upload is in progress.
If the WiMAX Device’s IP address is different in the configuration file you selected, you may need to
change the IP address of your computer to be in the same subnet as that of the default
management IP address (192.168.5.1). See the Quick Start Guide or the appendices for details on
how to set up your computer’s IP address.
You might have to open a new browser to log in again.
If the upload was not successful, you are notified with an error message.
12.16 Factory Defaults
Use this screen to restore the WiMAX Device to its factory default settings.
Table 94 Restore
LABEL DESCRIPTION
Configuration File Click Browse... then browse to the location of a firmware upgrade file and select
it.
Click File Restore to upload the specified configuration to the WiMAX Device
and replace the current settings.
Backup
Configuration File
URL
Enter the URL or IP address of the backup configuration file’s location on the
network.
Click URL Restore to upload the specified configuration to the WiMAX Device
and replace the current settings.