A SERVICE OF

logo

14. Remove two screws (2) and lay the solenoid cover plate (3) down (it will still be
connected to the solenoid).
Reinstallation tip
The solenoid plate has three tabs at the bottom, one tab (5) slips under the printer sheet
metal base and the other two tabs (6) fit over the base.
Figure 6-36.
Pick-up/feed assembly removal (7 of 13)
15. Disconnect one spring (1).
16. Remove two screws (2) and remove the gear unit (3).
Figure 6-37.
Pick-up/feed assembly removal (8 of 13)
17. Remove two screws (1).
232 Chapter 6 Removal and replacement ENWW