3. Refer to the pick-up/feed guide assembly removal procedure, steps 1 through 12, and
remove the right side gear plate. See
Pick-up/feed assembly removal.
CAUTION
It is important to refer to the pick-up/feed assembly removal procedure's "Reinstallation
notes" to ensure correct installation of this assembly. If reassembly is not performed
correctly, it can result in damage to the print cartridge drive pins, the image drive assembly
drive pins, and the swing guide mechanism.
4. Remove the e-clip (1), remove two screws (2), and then remove the gear plate (3).
Reinstallation tip
When reinstalling the gear plate, ensure that the gear (4) is turned all the way
counterclockwise as shown below. Refer to the above caution for reinstallation
information.
Figure 6-110.
Primary transfer roller engaging motor removal (1 of 4)
5. Remove the one screw (1) from the rear swing guide rail (2) and remove the rail.
6. Pull gear (3) and its shaft out to the left.
ENWW Motor and fans 275
