4. Disconnect four connectors (1) and remove the power supply (2).
Figure 6-129.
Low voltage power supply PCB removal (2 of 2)
Memory controller PCB removal
1. Open the front door, remove the transfer unit, and the print cartridges. See Transfer unit
removal and Print cartridge removal.
2. Disconnect the left rod bracket from the front door by removing two screws from the
bracket. See
Pick-up/feed assembly removal, step 4.
3. Remove two screws (1) and pull the shield plate (2) out. Adjust the position of the swing
guide, as required to access the screws. (The left swing guide has been removed for
clarity in illustrating this removal procedure. It is not necessary to remove the swing
guide to remove this PCB.)
Figure 6-130.
Memory controller PCB removal (1 of 2)
286 Chapter 6 Removal and replacement ENWW
