A SERVICE OF

logo

Open as PDF
next previous
8. While holding the media sensor bar upright, remove any visible pieces of paper (1).
9. When the paper is removed, lower the bottom media sensor bar back down into place.
10. Swing the top flat bar down into place over the bottom media sensor bar.
11. Open the front door to its fully open position and reinstall the yellow and magenta
cartridges.
12. Reseat the transfer unit by holding the blue handles and inserting the left side first. Align
the two holes (2) in the transfer unit with the pegs (1) on the printer door and lower the
unit into place. Do not touch the black surface (transfer belt) or the contacts on the left
side of the transfer unit.
Figure 7-3.
Left side of front door
13. Close the front door.
Paper is wrinkled or folded
ENWW Paper path troubleshooting 367