A SERVICE OF

logo

6. Push both swing guides all the way back (1), remove four screws (2), and remove the
feed guide (3).
Figure 6-50.
Feed guide removal (2 of 2)
Reinstallation tip
Make sure that the drive shaft (1) on the feed guide fits correctly into the drive shaft in
the printer (2).
Figure 6-51.
Feed guide/printer drive shaft connection
Reinstallation tip
Make sure that the two tabs (1) at the rear of the feed guide fit into the slots (2), located
just in front of the fuser opening (viewed from the rear of the printer with the fuser
removed).
Figure 6-52.
Feed guide unit tab locations
ENWW Main assembly parts 241