A SERVICE OF

logo

Feed guide unit removal
1. Release the right and left rod brackets from the front door. See Pick-up/feed assembly
removal removal procedure, steps 1 through 5.
2. Push the swing guides all the way back.
3. Remove the secondary transfer charging roller. See
Secondary transfer charging roller
removal.
4. Remove the fuser. See
Fuser removal.
5. Using both hands, grasp the air duct (2) and apply pressure (by pinching the top and
bottom of the duct at the locations indicated by callouts (1) to release two claws (1)
located on the bottom rear of the duct. Swing the front of the air duct upwards to remove
it.
Figure 6-49.
Feed guide unit removal (1 of 2)
240 Chapter 6 Removal and replacement ENWW