18. Unhook one claw (2) and pull the Tray 2 pick-up gear (3) off the shaft.
Reinstallation tip
When installing this gear (3) it may be necessary to hold the pick-up feed roller steady
while inserting the gear onto the shaft.
19. Remove one screw (4) and remove the solenoid cover and solenoid (5).
Figure 6-38.
Pick-up/feed assembly removal (9 of 13)
20. Lift the bushing tab (1) up slightly, rotate it in the direction of the arrow (2), and then pull
both the bushing and the Tray 2 pick-up roller shaft (3) out of the printer.
Reinstallation tip
When reinstalling the shaft (5), it should extend out approximately 17 mm (about (5/8
inch)).
21. Lift the bushing tab (4) up slightly, rotate it in the direction of the arrow (5), and then pull
both the bushing and the metal shaft (6) out of the printer. The shaft has a pin through
the end that requires you rotate the shaft while pulling on it to release it.
Figure 6-39.
Pick-up/feed assembly removal (10 of 13)
ENWW Main Assemblies 233
