Filter
Top Products
Access Management Configuration Commands 117
To display the access management configurations on Ethernet1/0/1:
<4500> display am ethernet1/0/1
Ethernet1/0/1
Status : disabled
IP Pools : (NULL)
display isolate port Syntax
display isolate port
View
Any view
Parameter
none
Description
Use the display isolate port command to view port isolation information.
Example
To display port isolation information, enter the following:
<4500>display isolate port
Isolated port(s) on UNIT 1:
Ethernet1/0/1
port isolate Syntax
port isolate
undo port isolate
View
Ethernet Port View
Parameter
none
Description
Use the port isolate command to add a port to an isolation group using the
following commands, and achieves port-to-port isolation between this port and
Table 11 Output Description of the display am Command
Field Description
Status AM state on the port: enabled or disabled
IP Pools IP pools. NULL represents no configuration. Each IP address section is
represented in X.X.X.X (number), of these, "X.X.X.X" represents the
first address, and "number" represents that "number" consecutive IP
addresses from the beginning of this address are within the IP pools
Isolate Ports Isolate ports. NULL represents no configuration