Filter
Top Products
Ethernet Port Link Aggregation Commands 69
Local:
Port-Priority: 32768, Oper key: 2, Flag: 0x3d
Remote:
System ID: 0x8000, 000e-84a6-fb00
Port Number: 2, Port-Priority: 32768 , Oper-key: 10, Flag: 0x3d
Received LACP Packets: 8 packet(s), Illegal: 0 packet(s)
Sent LACP Packets: 9 packet(s)
Related command: display link-aggregation verbose.
display lacp system-id Syntax
display lacp system-id
View
Any view
Parameter
None
Description
Use the display lacp system-id command to view actor system ID, including
system priority and system MAC address.
Related command: link-aggregation.
Example
To display the local system ID.
<4500>display lacp system-id
Actor System ID: 0x8000, 00e0-fc00-0100
lacp enable Syntax
lacp enable
undo lacp enable
View
Ethernet Port View
Parameter
None
Description
Use the lacp enable command to enable LACP.
Use the undo lacp enable command to disable LACP.
The Switch will select the lowest port number as the master port for the link
aggregation. This applies to all types of link aggregation. If the aggregation spans
a stack of units (only avaliable on the Switch 4500-EI) and the same ports are
used, the unit number will be the tie-breaker. For example, 1/0/1 and 2/0/1 are in
an aggregation. Port 1/0/1 will be the master port.