Filter
Top Products
156 CHAPTER 6: USING ROUTING PROTOCOL COMMANDS
System View: return to User View with Ctrl+Z.
[4500]rip
[4500-rip]peer 202.38.165.1
preference Syntax
preference value
undo preference
View
RIP view
Parameter
value Enter the preference level, in the range 1 to 255. By default, the value is
100.
Description
Use the preference command to configure the route preference of RIP.
Use the undo preference command to restore the default preference.
The default value of each routing protocol is determined by the specific routing
policy. This “preference” determines the optimal route in the IP routing table. You
can use this command to modify the RIP preference.
Example
To specify a RIP preference of 20, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]rip
[4500-rip]preference 20
reset Syntax
reset
View
RIP view
Parameter
None
Description
Use the reset command to reset the system configuration parameters of RIP.
When you need to re-configure parameters of RIP, this command can be used to
restore to the default setting.
Example
Reset the RIP system.
<4500>system-view
System View: return to User View with Ctrl+Z.