Filter
Top Products
340 CHAPTER 12: USING SYSTEM MANAGEMENT COMMANDS
The information displays in the following format:
Unit 1
Board 0 CPU busy status:
11% in last 5 seconds
12% in last 1 minute
14% in last 5 minutes
display device Syntax
display device [ unit unit-id ]
View
All views
Parameter
unit unit-id: Specify the Unit ID of the switch.
Description
Use the display device command to display the module type and working status
information of a card, including physical card number, physical daughter card
number, number of ports, hardware version number, FPGA version number,
version number of BOOTROM software, application version number, address
learning mode, interface card type and interface card type description, etc.
Example
Show device information.
<SW4500>display device
Unit 1
SlotNo SubSNo PortNum PCBVer FPGAVer CPLDVer BootRomVer AddrLM Type State
0 0 24 REV.A NULL 000 200 IVLMAIN Norma
display fan Syntax
display fan [ unit unit-id ]
View
All views
Table 32 Display information
Field Description
Board 0 CPU busy status The busy status of the Switch
11% in last 5 seconds The CPU occupancy rate is 11% at last 5 seconds
12% in last 1 minute The CPU occupancy rate is 12% at last 1 minute
14% in last 5 minutes The CPU occupancy rate is 14% at last 5 minutes