Filter
Top Products
218 CHAPTER 10: USING RSTP COMMANDS
Parameter
interface interface_list: Specifies the Ethernet port list, including multiple
Ethernet ports. Expressed as
interface _list = { { interface_type
interface_num | interface_name } [ to { interface_type interface_num
| interface_name } ] }&<1-10>.
For details about interface_type, interface_num and interface_name, refer to
the
port command in this guide.
&<1-10>: Indicates the preceding parameter can be input up to 10 times.
Description
Use the reset stp command to reset the statistics information about Rapid
Spanning Tree Protocol (RSTP).
This command can be used to clear the statistics information about a specified
port. If no port is specified, the statistics information of all the ports of the device
will be cleared.
Related command: display stp.
Example
To clear the statistics information about Ethernet1/0/1 through Ethernet1/0/3,
enter the following:
<4500>reset stp interface Ethernet1/0/1 to Ethernet1/0/3
stp Syntax
stp { enable | disable }
undo stp
View
Ethernet Port View
Parameter
enable: Enables RSTP on a device or a port.
disable: Disables RSTP on a device or a port.
Description
Use the stp enable command to enable RSTP on a device or port.
Use the stp disable command to disable RSTP on a device or port.
Use the undo stp command to disable RSTP on a device.
By default, RSTP is enabled on the Switch and all ports.
If the parameters of RSTP have not been set for the device or the ports before
RSTP is enabled on the device, they will take the default values. Before or after
RSTP is enabled, you can use the configuration command to set RSTP parameters