Filter
Top Products
3Com Switch 8800 Configuration Guide Chapter 17 Static Route Configuration
17-4
17.3 Displaying and Debugging Static Route
After the above configuration, execute the display command in any view to display the
running of the static route configuration, and to verify the effect of the configuration.
Table 17-4 Display and debug the routing table
Operation Command
Display routing table summary
display ip routing-table
Display routing table details
display ip routing-table verbose
Display the detailed information of a
specific route
display ip routing-table ip_address
[ mask ] [ longer-match ] [ verbose ]
Display the route information in the
specified address range
display ip routing-table ip_address1
mask1 ip_address2 mask2 [ verbose ]
Display the route filtered through the
specified basic access control list (ACL)
display ip routing-table acl
{ acl-number | acl-name } [ verbose ]
Display the route information that is
filtered through the specified ip prefix list
display ip routing-table ip-prefix
ip-prefix-number [ verbose ]
Display the routing information
discovered by the specified protocol
display ip routing-table protocol
protocol [ inactive | verbose ]
Display the tree routing table
display ip routing-table radix
Display the statistics of the routing table
display ip routing-table statistics
Display the routing information about the
VPN instance
display ip routing-table vpn-instance
vpn-instance-name
17.4 Typical Static Route Configuration Example
I. Network requirements
As shown in Figure 17-1, the masks of all the IP addresses are 255.255.255.0. It is
required that all the hosts or the Switch 8800 can be interconnected in pairs by static
route configuration.