Filter
Top Products
3Com Switch 8800 Configuration Guide
Chapter 40 AAA and RADIUS/TACACS+ Protocol Con
figuration
40-14
Table 40-11 Set IP Address and Port Number of RADIUS Server
Operation Command
Set IP address and port number of primary
RADIUS authentication/authorization server.
primary authentication
ip-address [ port-number ]
Restore IP address and port number of primary
RADIUS authentication/authorization or server
to the default values.
undo primary authentication
Set IP address and port number of primary
RADIUS accounting server.
primary accounting ip-address
[ port-number ]
Restore IP address and port number of primary
RADIUS accounting server or server to the
default values.
undo primary accounting
Set IP address and port number of secondary
RADIUS authentication/authorization server.
secondary authentication
ip-address [ port-number ]
Restore IP address and port number of
secondary RADIUS
authentication/authorization or server to the
default values.
undo secondary
authentication
Set IP address and port number of secondary
RADIUS accounting server.
secondary accounting
ip-address [ port-number ]
Restore IP address and port number of
secondary RADIUS accounting server or server
to the default values.
undo secondary accounting
By default, as for the "system" RADIUS scheme created by the system:
The IP address of the primary authentication server is 127.0.0.1, and the UDP port
number is 1645.
The IP address of the secondary authentication server is 0.0.0.0, and the UDP port
number is 1812.
The IP address of the primary accounting server is 127.0.0.1, and the UDP port number
is 1646
The IP address of the secondary accounting server is 0.0.0.0, and the UDP port
number is 1813;
As for the newly created RADIUS scheme:
The IP address of the primary/secondary authentication server is 0.0.0.0, and the UDP
port number of this server is 1812;
The IP address of the primary/secondary accounting server is 0.0.0.0, and the UDP
port number of this server is 1813;
In real networking environments, the above parameters shall be set according to the
specific requirements. For example, you may specify 4 groups of different data to map