Filter
Top Products
3Com Switch 8800 Configuration Guide Chapter 49 NTP Configuration
49-9
server: Allow local NTP time service request and control query. However, the local
clock will not be synchronized by a remote server.
peer: Allow local NTP time service request and control query. And the local clock will
also be synchronized by a remote server.
49.2.8 Setting Maximum Local Sessions
This configuration task is to set the maximum local sessions.
Perform the following configurations in system view.
Table 49-13 Set the maximum local sessions
Operation Command
Set the maximum local sessions
ntp-service max-dynamic-sessions
number
Resume the maximum number of local
sessions
undo ntp-service
max-dynamic-sessions
number specifies the maximum number of local sessions, ranges from 0 to 100, and
defaults to 100.
49.3 Displaying and Debugging NTP
After completing the above configurations, you can use the display command to show
how NTP runs and verify the configurations according to the outputs.
In user view, you can use the debugging command to debug NTP.
Table 49-14 Display and debug NTP
Operation Command
Display the status of NTP service
display ntp-service status
Display the status of sessions maintained by
NTP service
display ntp-service sessions
[ verbose ]
Display the brief information about every NTP
time server on the way from the local
equipment to the reference clock source.
display ntp-service trace
Enable NTP debugging
debugging ntp-service