Filter
Top Products
3Com Switch 8800 Configuration Guide Chapter 46 System Maintenance and Debugging
46-12
Table 46-15 Send the configuration information to the console terminal.
Device Configuration
Default
value
Configuration description
Enable info-center
By default,
info-center
is enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information
output direction to the
Console
— —
Set information source —
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
turn on the switch of the
corresponding module before
defining output debugging
information.
Switch
Enable terminal
display function
—
You can view debugging
information after enabling
terminal display function
3) Sending the configuration information to the monitor terminal
Table 46-16 Send the configuration information to the monitor terminal
Device Configuration
Default
value
Configuration description
Enable info-center
By default,
info-center
is enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information
output direction to the
monitor
— —
Set information source —
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
turn on the switch of the
corresponding module before
defining output debugging
information.
Switch
Enable the terminal
display function and
this function for the
corresponding
information
—
For Telnet terminal and dumb
terminal, to view the information,
you must enable the current
terminal display function using
the terminal monitor command.
4) Sending the configuration information to the log buffer.