Filter
Top Products
3Com Switch 8800 Configuration Guide Chapter 39 802.1x Configuration
39-11
supp-timeout-value: Specifies how long the duration of an authentication timeout timer
of a Supplicant is. The value ranges from 10 to 120 in units of second and defaults to
30.
tx-period: Specifies the transmission timeout timer. After the Authenticator sends the
Request/Identity request packet which requests the user name or user name and
password together, the tx-period timer of the Authenticator begins to run. If the
Supplicant does not respond back with authentication reply packet successfully, then
the Authenticator will resend the authentication request packet.
tx-period-value: Specifies how long the duration of the transmission timeout timer is.
The value ranges from 10 to 120 in units of second and defaults to 30.
39.2.11 Enabling/Disabling quiet-period Timer
You can use the following commands to enable/disable a quiet-period timer of an
Authenticator (such as a Switch 8800). If an 802.1x user has not passed the
authentication, the Authenticator will keep quiet for a while (which is specified by dot1x
timer quiet-period command) before launching the authentication again. During the
quiet period, the Authenticator does not do anything related to 802.1x authentication.
Perform the following configuration in system view.
Table 39-11 Enable/Disable a quiet-period timer
Operation Command
Enable a quiet-period timer
dot1x quiet-period
Disable a quiet-period timer
undo dot1x quiet-period
By default, quiet-period timer is disabled.
39.3 Displaying and Debugging 802.1x
After the above configuration, execute display dot1x command in any view to display
the running of the 802.1x configuration, and to verify the effect of the configuration.
Execute reset dot1x statistics command in user view to reset 802.1x statistics.
Execute debugging command in user view to debug 802.1x.
Table 39-12 Display and debug 802.1x
Operation Command
Display the configuration, running and
statistics information of 802.1x
display dot1x [ sessions | statistics |
enabled-interface ] [ interface
interface-list ]
Reset the 802.1x statistics information
reset dot1x statistics [ interface
interface-list ]