Filter
Top Products
3Com Switch 8800 Configuration Guide Chapter 46 System Maintenance and Debugging
46-13
Table 46-17 Send the configuration information to the log buffer
Device Configuration
Default
value
Configuration description
Enable info-center
By default,
info-center
is enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information
output direction to the
logbuffer
—
You can configure the size of the
log buffer at the same time.
Switch
Set information source —
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
turn on the switch of the
corresponding module before
defining output debugging
information.
5) Sending the configuration information to the trap buffer.
Table 46-18 Send the configuration information to the trap buffer
Device Configuration
Default
value
Configuration description
Enable info-center
By default,
info-center
is enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information
output direction to the
trapbuffer
—
You can configure the size of the
trap buffer at the same time.
Switch
Set information source —
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
turn on the switch of the
corresponding module before
defining output debugging
information.
6) Sending the configuration information to SNMP
Table 46-19 Send the configuration information to SNMP
Device Configuration Default value Configuration description
Switch
Enable
info-center
By default,
info-center is
enabled.
Other configurations are valid
only if the info-center is
enabled.