Filter
Top Products
3Com Switch 8800 Configuration Guide Chapter 42 HA Configuration
42-3
Table 42-3 Enable/Disable automatic synchronization
Operation Command
Enable automatic synchronization
slave auto-update config
Disable automatic synchronization
undo slave auto-update config
By default, the automatic synchronization of system is enabled.
42.2.4 Synchronizing the Configuration File Manually
Although the system can perform the synchronization automatically, the
synchronization can occur only when the Fabric saves its configuration file. If the user
expects to determine the backup of the configuration file by himself, he can do it
manually to backup the configuration file saved in the Fabric.
Perform the following configuration in user view.
Table 42-4 Synchronize the configuration file manually
Operation Command
Synchronize the configuration file
manually
slave update configuration
This operation can backup the configuration file to the slave board only if a slave
system is available. The configuration file will be fully copied once at every time the
operation is executed.
42.2.5 Configuring the Load Mode of the Fabric and Slave Board
The Switch 8800 supports two kinds of load modes (balance and single) between the
Fabric and slave board. You can use the xbar command to configure XBar (cross bar)
load mode.
Perform the following configuration in system view.
Table 42-5 Configure the XBar load mode
Operation Command
Configure the load mode of the Fabric
and slave board
xbar [ load-balance | load-single ]
By default, the load mode of the Fabric and slave board is load-single.