Filter
Top Products
3Com Switch 8800 Configuration Guide Chapter 46 System Maintenance and Debugging
46-22
1) Enabling info-center
Perform the following configuration in system view.
Table 46-34 Enable/disable info-center
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to the log buffer
Perform the following configuration in system view.
Table 46-35 Configure to output information to log buffer
Operation Command
Output information to log buffer
info-center logbuffer [ channel
{ channel-number | channel-name } | size
buffersize ]*
Cancel the configuration of
outputting information to log buffer
undo info-center logbuffer [ channel | size ]
3) Configuring information source on the switch
By this configuration, you can define the information that sent to log buffer is generated
by which modules, information type, information level, and so on.
Perform the following configuration in system view:
Table 46-36 Define information source
Operation Command
Define information source
info-center source { modu-name | default }
channel { channel-number | channel-name } [ debug
{ level severity | state state }* | log { level severity |
state state }* | trap { level severity | state state }* ]*
Cancel the configuration of
information source
undo info-center source { modu-name | default |
all } channel { channel-number | channel-name }