Filter
Top Products
3Com Switch 8800 Configuration Guide Chapter 46 System Maintenance and Debugging
46-2
Table 46-3 Set the time zone
Operation Command
Set the local time
clock timezone zone_name { add |
minus } HH:MM:SS
Restore to the default UTC time zone
undo clock timezone
By default, the UTC time zone is adopted.
46.1.4 Setting the Summer Time
You can set the name, starting and ending time of the summer time.
Perform the following configuration in user view.
Table 46-4 Set the summer time
Operation Command
Set the name and range of the summer
time
clock summer-time zone_name
{ one-off | repeating } start-time
start-date end-time end-date offset-time
Remove the setting of the summer time
undo clock summer-time
By default, the summer time is not set.
46.2 Displaying the State and Information of the System
The switch provides the display command for displaying the the system state and
statistics information.
For the display commands related to each protocols and different ports, refer to the
relevant chapters. The following display commands are used for displaying the system
state and the statistics information.
Perform the following operations in any view.
Table 46-5 The display commands of the system
Operation Command
Display the system clock
display clock
Display the system version
display version
Display the state of the debugging
display debugging [ interface
{ interface-name | interface-type
interface-number } ] [ module-name ]