Filter
Top Products
3Com Switch 8800 Configuration Guide Chapter 46 System Maintenance and Debugging
46-11
Logging buffer
4 logbuf
snmp 5 snmpagent
Log file 6 logfile
Note:
The settings in the 7 directions are independent from each other. The settings will take
effect only after enabling the information center.
The info-center of Ethernet Switch has the following features:
z Support to output log in 7 directions, i.e., Console, monitor to Telnet terminal,
logbuffer, loghost, trapbuffer, and SNMP log file.
z The log is divided into 8 levels according to the significance and it can be filtered
based on the levels.
z The information can be classified in terms of the source modules and the
information can be filtered in accordance with the modules.
z The output language can be selected between Chinese and English.
1) Sending the configuration information to the loghost.
Table 46-14 Send the configuration information to the loghost
Device Configuration
Default
value
Configuration description
Enable info-center
By default,
info-center
is enabled.
Other configurations are valid
only if the info-center is enabled.
Set the information
output direction to the
loghost
—
The configuration about the
loghost on the switch and that on
loghost must be the same;
otherwise the information cannot
be sent to the loghost correctly.
Switch
Set information source —
You can define which modules
and information to be sent out
and the time-stamp format of
information, and so on. You must
turn on the switch of the
corresponding module before
defining output debugging
information.
Loghost
Refer to configuration
cases for related log
host configuration
— —
2) Sending the configuration information to the console terminal.