Filter
Top Products
Configuration - Devices
20
TVM-1600 Endeleo Managed TV Distribution Hub
Selecting a Device Protocol
The Protocol drop down box displays the pre-learned IR protocols for the remote devices. This is the
protocol used by Device’s Remote Control to power off, power on etc.
To assign a protocol to a device:
1. Click on the Devices option.
2. Click on the downward arrow in the Protocol column for the relevant device.
3. Select the correct protocol (previously learned) to be assigned to this device.
Device Control
The bottom bar of the status page allows a limited range of Integrated Device Management instructions
to be performed (FIG. 19).
Several commands are available, depending on which control option is selected. Some sample controls
are explained below;
Power Off – Sends IR or serial code associated with powering a display device off.
Power On – Sends IR or serial code associated with powering a display device on.
A/V select –Sends IR or serial code associated with selecting AV input on a display device.
Play – play the device.
It is possible to send two commands to a device(s) using a single instruction. This is particularly useful
where the display device does not return from standby into AV mode.
For more information on IR protocol learning, refer to the Advanced Administration
section of this manual.
FIG. 19 Bottom toolbar of the Devices page