Filter
Top Products
IR Learning and IR Device Control
39
TVM-1600 Endeleo Managed TV Distribution Hub
3. Push Enter to execute the command. The process will then guide you through what to do;
Point the remote control at the IR port (Right Window Only) on the front of the TVM-1600
and press the appropriate key e.g. power off from the remote when prompted.
Continue to enter commands for the device (FIG. 42).
Example: "r 12 1" will learn the Power Off function of the TV from the remote control to the
TVM-RX03 unit attached to port 1. Upon hitting enter aim the remote control of the TV at the
TVM-1600 and press the “Power Off” button when prompted.
Saving the IR File to your PC
Once an IR protocol has been learned for a specific port it can simply be copied to a PC, then copied
across the network to other ports using the tftp command.
To save the IR file;
1. Open a command prompt.
2. At the command prompt type the following command;
tftp –i [IP address of hub] get iname.port number
iname is the user-defined name given to this IR device
The port number suffix relates to the port number (e.g. ".001" is for port 1, ".016" for port 16,
where the IR file is stored).
A sample command for an IR device name “iSonyLCD” on port 1 is listed below (FIG. 43).
tftp –i 192.168.1.200 get iSonyLCD.001
3. Upon completion, a successful transfer message is displayed (FIG. 44).
FIG. 42 Learning the Power off IR command
AMX advises you create a folder in which to save your IR Files, and change to that
directory in the command prompt.
When naming an IR file, the file must always start with the letter “i”, to signify that this
is an IR protocol.
FIG. 43 Saving the IR commands
FIG. 44 Successfully saved IR commands