Filter
Top Products
Wiring and Connections
15
UDM-1604 Endeleo Multi-Format Distribution Hub
IEC Power Connector
The UDM-1604 uses a universal switch-mode power supply, which operates from 90-264V AC,
50/60Hz, with a power consumption of 130W fully loaded.
The rating label found to the bottom left of the hub, beneath the IEC connector, contains
important information applicable to the Hub's installation environment.
The Power On/Off switch is located beside the IEC power connector.
Powering the UDM-1604 Hub On
1.
Ensure a standard PC mains lead has been connected to the 3-pin power connection, and then
connected to a mains power source.
2. Flip the power switch down to its On (|) position.
Powering the UDM-1604 Hub Off
To turn the UDM-1604 off, flip the Power switch to it’s Off (0) position.
As a Class 1 appliance the UDM-1604 should be connected to a mains supply with a
protective earthing connection.
Where a mains plug (or appliance coupler) is used in the event of a fault, the hub can
be disconnected from the mains by removing the lead from the IEC inlet or from the
mains socket.
It is important that the hub is installed in such a way that this method remains readily
operable.
The user should have easy access to either the IEC inlet or the mains socket in the
event of a fault.