Filter
Top Products
Advanced Administration
60
UDM-1604 Endeleo Multi-Format Distribution Hub
The table below describes typical values returned when using the ? command on an input port.
User Outputs
1.
To view a port’s properties, type a question mark before the port number.
Ensure there is a space between the question mark and the number. (FIG. 79)
For example ? 1 will display Port 1 properties.
2. Push Enter once the command has been entered.
3. The table below describes typical values returned when using the ? command on a Hub port.
Hub Temperature
To view the Hub’s internal temperature;
1. Connect to the UDM Hub using an appropriate tool (e.g. Hyperterminal).
2. At the command prompt type in –h to view the Hub’s internal temperature. (FIG. 80)
Multi-Format Input Configuration
Value Description
129 Input A
00.06.00 Input Controller Version
XGA Extended Graphics Array
1024x768 Screen Resolution
799 Vertical lines on screen
H+ Horizontal polarity (+/-)
V+ Vertical polarity (+/-)
FIG. 79
Querying a port
Value Description
Port 1 Port number on UDM Hub
01.11.00 Port Controller version
Clock Master 8406 Master (version)
Disconnected / Connected Connected to RX
Port Power On or Off
Port Number Checksum Port in Master or Slave hub
FIG. 80
Displaying the Hub temperature