Filter
Top Products
Protocols and IR Learning
33
UDM-1604 Endeleo Multi-Format Distribution Hub
3. Name the Infrared protocol appropriately and click on Initialise (FIG. 36).
4. The hub prompts for the relevant action which is to be performed (e.g. vol up). Select the relevant
action from the Action drop down menu (e.g. vol up - FIG. 37).
5. Click on Step 1. A message saying Press key on remote will appear. Click the key on the device’s
remote control which will manage the action vol up (FIG. 38).
6. Click on Step 2. A message saying Press key on remote will appear. Click the key on the device’s
remote control which will manage the action vol up (FIG. 39).
A new table for this device’s remote control is what is actually being created. When
the administrator decides to create further commands e.g power off, power on
particular to this remote control they will be stored within this table. If new commands
are to be created in future ensure the correct IR Protocol has been selected before
recording new commands to ensure commands are stored in the correct table. There
is one protocol/table per UDM Receiver.
FIG. 36 Creating a new IR protocol (table)
FIG. 37 Creating a new action for an IR protocol
Ensure the device’s remote control is pointing to the IR sensor located at the front of
the UDM Hub when performing key presses. If not the key presses may not be stored
in the UDM Hub.
FIG. 38 Configuring the device’s remote Step 1
FIG. 39 Configuring the device’s remote Step 2
The IR learning process requires that the command on the device’s remote is learned
twice i.e the same remote control command needs to be repeated at Step 2.