Filter
Top Products
Input Configuration
27
UDM-1604 Endeleo Multi-Format Distribution Hub
Compensating Video Using the UDM-RC02 Remote Control
Video can also be compensated using the UDM-RC02 Endeleo Multi-Format IR Remote Control
(FG-UDM-RC02).
To compensate video using the UDM-RC02 remote control;
1. Ensure the Endeleo RX Infrared bud is attached to the receiver at the IRRX port (FIG. 29).
2. To enter compensation mode push button A then button B on the UDM-RX02 remote control.
3. The amber LED at the Cat5 port on the RX unit will start to flash – indicating the RX is in
compensation mode.
4. Use the buttons on the RX02 remote control to adjust appropriately the following up or down;
Sharpness;
Gain and
Red, Green and Blue.
5. Once the image displayed is of an acceptable quality push the Esc button on the RX02 remote
control to exit compensation mode.
FIG. 29 UDM-RC02 Endeleo Multi-Format IR Remote Control
Infrared RX port
UDM-RC02
Infrared RX bud
The compensation settings will be specific to this RX unit and stored internally i.e. if
this RX unit is replaced or swapped out the compensation settings will travel with the
RX unit. It may therefore be necessary to re-compensate the RX / replacement RX if
this RX unit is to be used elsewhere or is being replaced.