Filter
Top Products
Operating the UDM Hub
41
UDM-1604 Endeleo Multi-Format Distribution Hub
6. To exit Passthrough Mode press the TV key on the Sky remote or a non-passthrough key on the
remote control.
Passthrough Mode (Inputs TVM-AV1 – TVM-AV4)
Similarly a TVM Input (TVM-AV1 – TVM-AV4) can be configured for Passthrough Mode.
Observe the following guidelines;
Ensure the IR Blaster is connected to the correct IR port at the rear of the UDM Hub. For
example IR Port 1 – which will be associated with Device 1 and input TVM-AV1.
The relevant Device Number is selected to reflect the relevant IR Port (same Device number as
IR port on the rear of the UDM Hub).
Ensure the Device number is associated with the relevant TVM-AV port. For example Device
1 is associated with TVM-AV1.
The protocol for the Device (for example a Sky box) has been learned. Refer to Advanced
Administration in this guide.
Relevant key has been assigned in User Control to enter Passthrough Mode for the TVM-AV
input.
The TVM-AV Input has been enabled for Passthrough Mode.
Using Passthrough Mode
Once a device has been configured for Passthrough Mode the relevant remote control is used to control
the device.
Press the previously configured key on the relevant remote control (UDM-RX01 or Sky remote control)
to enter passthrough mode.
If accessing a Sky Box through passthrough, click on the Sky button on the Sky remote
control. Now use the Sky Remote control as normal. (Press TV on the Sky remote to exit
passthrough mode).
If accessing a DVD player through passthrough, click on the relevant button on the DVD
remote control to play, pause, stop eject etc. Use the DVD Remote control as normal.
If accessing an Endeleo TVM Hub through passthrough, click on the Up or Down channel on
the TVM remote control, to toggle between channels.
Exiting Passthrough Mode
To exit passthrough mode, click on any key on the remote control (which accessed passthrough mode)
which is not configured as a control enabled key. If accessing a Sky box press TV on the Sky remote to
exit passthrough mode.
If a TVM Hub is directly connected to port TVM-AV1 on the UDM Hub and an IR
Blaster connected to IR Port 1 (at the rear of the UDM Hub) is associated with Input
A, then only channel changes will be permitted on the TVM Hub – i.e. NON-
Passthrough Mode.