Filter
Top Products
Protocols and IR Learning
34
UDM-1604 Endeleo Multi-Format Distribution Hub
Updating the UDM Receiver With the IR Protocol
1. Ensure the Infrared Protocol has been created previously.
2. Click on the Status page.
3. Click on the port number hyperlink which the device is attached to. It is the Endeleo RX unit
which will transmit the IR command to the devices IR interface.
4. Once the port properties become visible click on the arrow to the right of the Protocol field.
5. Select the IR protocol which this RX unit will download. This may take a few minutes depending on
how many commands are within the table.
6. A message will appear saying “Loading Protocol – Please wait” once this has disappeared the IR
protocol has been downloaded to the RX device. IR commands can now be sent from the Hub Web
pages to the device.
Deleting Protocols
Protocols can be deleted individually by type (Delete) or all protocols can be removed from the UDM
Hub (Delete all) i.e. all serial and all Infrared protocols can be deleted using Delete All.
1. Click on the Protocols option.
2. To delete a protocol click the Delete hyperlink in the serial section to delete a serial protocol or click
the Delete hyperlink in the Infrared section to delete an infrared protocol.
Deleting All Protocols (Serial and IR)
All protocols can be deleted from the UDM Hub.
1. Click on the Protocols option.
2. To delete all protocols click the Delete all hyperlink in the Serial section i.e. the top half of the
screen. This deletes all Serial and all Infrared protocols.
A UDM-RX01/02 Receiver, which will issue the relevant IR commands to the device,
must be connected to the relevant port via a Cat5/e/6 cable. Remember the IR
commands are stored within the Receiver.
The last created or currently highlighted serial or infrared protocol will be deleted
when using the Delete hyperlink.