Filter
Top Products
Operating the UDM Hub
38
UDM-1604 Endeleo Multi-Format Distribution Hub
Issuing Commands To Multiple Ports
As with the input selection it is also possible to send multiple control commands to all or selected ports.
1. Click on the Status option.
2. Select the check boxes for the outputs to be changed (the Include All link simply toggles all the
channels to be included on or off). The ports will now be highlighted in orange.
3. Click on the downward arrow to the right of a Control field in one of the selected ports. Select the
control to be executed.
4. Select the Execute button (FIG. 46).
Issuing Commands to Centrally Located Devices
It is also possible to control centrally located hardware such as DVD players, using the Devices page.
Remember an IR-TX bud coming from the rear of the UDM Hub will sit over the Device’s IR sensor.
1. Click on the Devices option from the main options (FIG. 47).
2. First select the device(s) you wish to control by clicking on its tick box beneath the Include column.
3. From the dark grey toolbar at the bottom of the screen select the control(s) that you wish to send.
4. Now click the Send to included hyperlink to issue the control(s).
Ensure a TX Infrared bud (smaller of the IR buds) is connected to the Endeleo RX
unit’s IRTX port. Attach it to the Device’s IR sensor before issuing a command. This
Infrared TX bud is used to transmit the command from the RX unit to the device’s
infrared sensor
Because the control strings are stored in the receiver units, a global command across
multiple ports will allow any range of display devices to be controlled simultaneously.
FIG. 47 Controls available for a device
2 commands (1st and 2nd, if necessary) can be sent.
The Device’s commands must have been learned by the UDM hub in order to
function. Refer to the Protocols and IR Learning section on page 31.