Filter
Top Products
Device Configuration and Control
29
UDM-1604 Endeleo Multi-Format Distribution Hub
Device Configuration and Control
The system allows "centrally located" devices connected to the rear of the UDM Hub e.g. VCR, DVD,
DVR or Satellite Decoders to be managed from the user port. This is performed through the Devices
page.
An Endeleo IR splitter will be needed for each of the IR ports if using 2 devices per IR port.
If only one device connected to IR TX port 1/2 it will by default be Device 1.
If only one device connected to IR TX port 3/4 it will by default be Device 3.
Adding Centrally Located Devices
1. Select the Devices option from the options to the left of the screen (FIG. 31).
2. Name the Device accordingly e.g. DVD Rack2.
3. Configure the Device with the relevant IR protocol if appropriate.
Refer to the Protocols and IR Learning section on page 31 for details on creating or learning IR
protocols.
4. Configure the Device with the correct Associated Input (i.e. where the Device, as an Input type, is
physically cabled to on the Hub);
If the Device is connected to an input at the rear of the Hub select the relevant associated input
(A-D).
If the Device is connected to a TVM-AV input at the front of the UDM Hub select the relevant
TVM-AV (1-4) associated input.
FIG. 30 UDM-1604 rear panel - IR TX ports
"Centrally Located "means the device is connected directly to the rear of the UDM
hub via the UDM IR ports (Tx1 – Tx4) using an Endeleo IR Tx bud.
The IR Tx bud will then transmit the IR signal from the UDM hub to the device.
FIG. 31 Devices screen
Ensure the correct port is selected. Device 1 refers to IR TX1 at the rear of the UDM
Hub, Device 4 refers to IR TX4 at the rear of the UDM hub.