Filter
Top Products
Copying customer data
Issue 1.0 December 2003 45
Copying customer data
To copy the customer’s data from the upgrade backup tape onto the system:
1. Verify that the customer’s “Upgrade Extract” tape is write-protected and is inserted in
the correct tape drive. Remove tapes from any other tape drives connected to the
system.
2. Load the upgrade tool CD-ROM. The CD-ROM is already in the drive if you did not
have to install any CMS patches.
The File Manager window should open. Click the cursor in an XTERM window.
Note:
Note: If the File Manager window does not open, enter the following commands to
start the volume manager:
/etc/init.d/volmgt stop
/etc/init.d/volmgt start
The File Manager window will open. Click the cursor in an XTERM window.
3. After about 15 seconds, enter:
cd /cdrom/cdrom0
4. Do one of the following:
● If running the command locally at the console, enter:
./cvue_copy
● Optionally, if running the command remotely on a dial-up line, enter:
nohup ./cvue_copy | tee /nohup.out
!
CAUTION:
CAUTION: If the dial-up modem line is dropped after starting this command with nohup,
reconnect to the system, but do not rerun this command. Use tail -f
/nohup.out to view the progress of the command. When finished viewing
the nohup.out file, press Del to break out of the command.
During the copy process, the status lamp on the tape drive flashes, and a list of files
being copied is displayed:
Reading admin data from /dev/rmt/X
.
.