Filter
Top Products
Setting the Informix configuration parameters
Issue 1.0 December 2003 65
Setting the Informix configuration parameters
The Informix Dynamic Server (IDS) parameters for CMS must be adjusted to optimize
system performance. Adjusting these parameters allows the system to fully use additional
processors and memory.
Note:
Note: During this procedure, both CMS and IDS must be turned off.
To adjust the IDS parameters, see the section “Setting the Informix configuration
parameters for CMS” in the chapter “Installing CMS and Supporting Software” of CMS R12
Software Installation, Maintenance, and Troubleshooting, 585-215-117.
Continue with Removing the upgrade files
on page 65.
Removing the upgrade files
The files used for the upgrade must be removed.
To remove the upgrade files:
1. Enter:
cd /cdrom/cdrom0
Note:
Note: If the above command does not work, enter the following commands to start
the volume manager:
/etc/init.d/volmgt stop
/etc/init.d/volmgt start
2. Do one of the following:
● If running the command locally at the console, enter:
./cvue_cleanup
● Optionally, if running the command remotely on a dial-up line, enter:
nohup ./cvue_cleanup | tee /nohup.out
The following message is displayed:
Beginning cvue_cleanup process...please wait.