Filter
Top Products
Chapter 6 Trunk Spans and Dialing Rules
CPSEE_TSP500 User Guide Version 4.0 Page 6-17
This document is confidential and proprietary to SER Solutions and is not for external use.
TONE_FREQ specifies the frequency of the tone to be detected after the tele-
phone number has been launched. It is the mid-range frequency of the
expected tone. The default value for this keyword is 450Hz.
TONE_RANGE
This keyword specifies the bandwidth of the frequency of the tone to be
detected after the telephone number has been launched. In other words, the
TSP will detect TONE_FREQ (plus or minus) (TONE_RANGE/2). The
default value for this keyword is 300Hz. See keyword TONE_FREQ.
TONE_TIME
This keyword specifies the duration of the tone to be detected after the tele-
phone number has been launched. The default value is 100 milliseconds.
TONE_TIME1 and TONE_TIME2
These keywords control the minimum time needed for detecting tone.
TOSSED_MESSAGES
This keyword indicates whether the TSP will or will not block on the transmit
socket. Blocking on this socket could cause the NMS queues to become to
overflow and become out of sync with the TSP application. The default value
of this keyword is zero.
TRUNK_CHECK_TIME
This keyword defines the time (in minutes) that trunks, disabled by too many
consecutive errors, will be retried. See keyword MAX_TRUNK_ERR
(default is five minutes).
TRUNK_GROUP_0 through TRUNK_GROUP_4
These keywords assign specific trunks to different trunk groups. Any trunks
not assigned are automatically assigned to Trunk Group 0.
Caution!
This item is intended for engi-
neering use, and should not be
modified unless instructed by
engineering.
Caution!
This item is intended for engi-
neering use, and should not be
modified unless instructed by
engineering.
Caution!
This item is intended for engi-
neering use, and should not be
modified unless instructed to
by engineering.
Caution!
This keyword should not be
turned on unless approved by
engineering.