Filter
Top Products
250 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Global Configuration commands
5
interface
Global Configuration commands
Configures a selected interface
This command is used to enter the interface configuration mode for the specified physical
Controller Virtual Interface (SVI) interface. If the VLANx (SVI) interface does not exist, it is
automatically created.
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
NOTE
The interfaces mentioned below are supported in the following platforms:
- ge <index> – Mobility RFS7000 Controller supports 4 GEs, Mobility RFS6000 Controller supports
8 GEs and Mobility RFS4000 Controller supports 5 GEs
- sa <index> – Mobility RFS7000 Controller supports 4 SAs and Mobility RFS4000 Controller
supports 6 SAs
- me1 – Supported with Mobility RFS7000 Controller, Mobility RFS4000 Controller and Mobility
RFS6000 Controller
- up1 – Supported with Mobility RFS6000 Controller and Mobility RFS4000 Controller.
NOTE
The interface mode leads to the config-if instance. For more information, see Interface Instance
on page 403. The prompt changes from
RFController(config) # to
RFController(config-if)
Syntax (Mobility RFS7000 Controller)
interface [<interface-name>|ge <1-4>|me1|sa <1-4>|vlan <1-4094>]
Syntax (Mobility RFS6000 Controller)
interface [<interface-name>|ge <1-8>|me1|up1|vlan <1-4094>]
Syntax(RFS4000)
interface [<interface-name>|ge <1-5>|me1|up1|sa <1-6>|vlan <1-4094>|wwan]