Filter
Top Products
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 277
53-1001931-01
Global Configuration commands
5
Parameters
Example
RFController(config)#redundancy discovery-period 20
RFController(config)#
RFController(config)#redundancy handle-stp enable
RFController(config)#
RFController(config)#redundancy heartbeat-period 20
RFController(config)#
RFController(config)#redundancy hold-period 25
RFController(config)#
RFController(config)#redundancy mode primary
RFController(config)#
auto-revert enable Enables auto-revert.
auto-revert-period
<1-1800>
Sets the redundancy auto-revert delay interval in minutes. The
default is 5 minutes.
critical-resource-ip
<ip_address>
Sets critical resource IP address.
• <ip_address> – IP address of the critical resource
dhcp-server enable Enables the DHCP redundancy protocol.
discovery-period <10-60> Sets the redundancy discovery interval in seconds. The default
is 30 seconds.
dynamic-ap-load-balance
[enable|
per-ap-client-threshold|
schedule-interval|
schedule-start-time|
trigger]
Configures the different Dynamic AP Load Balance feature. The
following are the configured options:
• enable – Enables Dynamic AP Load Balance
• per-ap-client-threshold <1-512> – Sets the threshold
per-ap client value to trigger Dynamic AP Load Balance.
Set a value between 1 & 512
• schedule-interval <1-336> – Sets the time interval days to
trigger Dynamic AP Load Balance
• schedule-start-time HH:MM <1-31> <1-12>
<2008-2035> – Sets the scheduled start time for
Dynamic AP Load Balance
• trigger [runtime|schedule] – Sets the trigger for running
Dynamic AP Load Balancing. Can be either runtime or
schedule
enable Enables the redundancy protocol.
group-id <1-65535> Sets the cluster ID (default cluster ID is 1).
handle-stp enable Delays the redundancy protocol state machine exec,
considering STP.
heartbeat-period <1-255> Sets the redundancy heartbeat interval.
hold-period <10-255> Sets the redundancy hold interval.
interface-ip <IP> Sets the redundancy interface IP address.
manual-revert Reverts standby to non-active mode.
member-ip <IP> Adds a member with the IP <IP> to this redundancy group.
mode [primary|standby] Sets the mode to either primary or standby.