Filter
Top Products
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 413
53-1001931-01
Interface config commands
12
Parameters
Usage Guidelines
IPv4 commands are not allowed on a L2 interface. Use the
ip access-group command to attach
an access list to an interface. Use the
no ip access-group command to remove the access list
from the interface
Use
mac access-group to attach a MAC access list to an interface
Use the
{no} ip [options] command to undo IP based interface configurations
Example
RFController(config-if)#ip access-group 110 in
RFController(config-if)#
RFController(config-if)#ip address 192.168.234.1/24
RFController(config-if)#
access-group
[<1-99>|
<100-199>|
<1300-1999>|
<2000-2699>]
Defines the access group
• <1-99> – Sets the IP standard access list
• <100-199> – Sets the IP extended access list
• <1300-1999> – Sets the IP standard access list
(expanded range)
• <2000-2699> – Sets the IP extended access list
(expanded range)
• WORD in – Defines the access list name
• in – Sets incoming packets
ip address [ <IP Mask>
{secondary}|dhcp]
Sets a static IP address and network mask for a Layer 3 SVI
(Controller Virtual Interface)
• <IP/ Mask> {secondary} – Sets the IP address (10.0.0.1/8)
• secondary – Defines an optional secondary IP address
• dhcp – Uses a DHCP Client to obtain an IP address for the
interface (this enables DHCP on a Layer 3 SVI)
helper-address <IP> Forwards DHCP and BOOTP packets
• <IP> - Defines the IP to which DHCP and BOOTP packets
are forwarded
NOTE: IP helper addresses can only be applied on SVI but not
on the physical interfaces.
nat [inside|outside] Sets Network Address Translation (NAT) parameters
• inside – Inside interface
• outside – Outside interface
arp [rate-limit
<1-1000000>|
trust]
Sets arp for the packets
• rate-limit <1-1000000> – Displays the allowed rate in
packets per second
• trust – Displays trust state for arp responses coming in this
interface
dhcp trust Sets dhcp trust state for dhcp responses coming in this
interface