Filter
Top Products
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 403
53-1001931-01
Chapter
12Interface Instance
In this chapter
•Interface config commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 403
Use the
(config-if) instance to configure the interfaces – Ethernet, VLAN and tunnel associated
with the controller.
To controller to this mode, use the command:
For Mobility RFS7000 Controller:
RFController(config)#interface [<interface-name>|ge <1-4>|me1|sa <1-4>|vlan
<1-4094>
RFController(config-if)#
For Mobility RFS6000 Controller:
RFController(config)#interface [<interface-name>|ge <1-8>|me1|up1|vlan
<1-4094>
RFController(config-if)#
For Mobility RFS4000 Controller:
RFSwitch(config)#interface [<interface-name>|ge <1-5>|me1|
up1|vlan <1-4094>|sa <1-6>|wwan]
RFSwitch(config-if)#
Interface config commands
Table 12 summarizes the (config-if) commands:
TABLE 12 Interface Config Commands
Command Description Ref.
clrscr Clears the display screen page 405
crypto Defines the encryption module page 406
description Creates an interface specific description page 407
duplex Sets the duplex mode used by the interface page 408
end Ends the current mode and moves to the EXEC mode page 409
exit Ends the current mode and moves to the previous mode page 410
help Displays the interactive help system page 411
ip Sets the IP address for the assigned ethernet, VLAN or tunnel page 412
mac Applies a MAC access list to a gigabit ethernet interface page 415
management Sets the selected interface as the management interface page 416