Filter
Top Products
568 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Radius configuration commands
19
rad-user
Radius configuration commands
Adds an existing RADIUS user to this group. If the RADIUS user is not available in the Onboard
RADIUS server’s database, create a new RADIUS user using the
rad-user command from within
the
(config-radsrv) mode.
For more information, see rad-user on page 580.
NOTE
It is strictly recommended to set hotspot simultaneous-users to 1 for corresponding WLAN as guest
user is being assigned access-duration.
Syntax
rad-user <name>
Parameters
Example
RFController(config-radsrv)#rad-user user1 password user1
RFController(config-radsrv)#group group1
RFController(config-radsrv-group)#rad-user user1
RFController(config-radsrv-group)#
rate-limit
Radius configuration commands
Sets the rate limit for the RADIUS Server group
Syntax
rate-limit [wired-to-wireless|wireless-to-wired ]
<100-100000>
Parameters
Usage Guidelines
Use
[no] rate-limit [wired-to-wireless|wireless-to-wired]to remove the rate limit
applied to the group.
[no] rate-limit [wireless-to-wired] sets the rate limit back to unlimited
Example
RFController(config-radsrv-group)#rate-limit wired-to-wireless 100
RFController(config-radsrv-group)#
RFController(config-radsrv-group)#rate-limit wireless-to-wired 1000
<name> Existing RADIUS user name
wired-to-wireless
<100-100000>
Down link direction from network to wireless client
• <100-100000> – Rate in the range of <100-100000> kbps
wireless-to-wired
<100-100000>
Up link direction from wireless client to network
• <100-100000> – Rate in the range of <100-100000> kbps