Filter
Top Products
658 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Wireless configuration commands
20
Parameters
Example
RFController(config-wireless)#self-heal interference-avoidance enable
RFController(config-wireless)#self-heal interference-avoidance hold-time 600
RFController(config-wireless)#self-heal neighbor-recovery enable
Note: reducing the configured transmit power of radios will ensure that there
is room to increase power when a neighbor fails
RFController(config-wireless)#self-heal neighbor-recovery neighbors 1 1
RFController(config-wireless)#
interference-avoidance Interference avoidance configuration.
enable Enables/disables interference avoidance.
hold-time <30-65535> The number of seconds to disable interference avoidance after a
detection. This prevents a radio from changing channels
continuously. Set the hold-time between 30-65535 seconds.
retries <0.0-15.0> Defines the average number retries (0-15) causing a radio to
re-run auto channel selection.
neighbor-recovery Invokes neighbor recovery configuration commands.
action [both|none|
open-rates|raise-power]
radio [<1-4096>|
<radio-list>]
Defines the radio’s self healing action when neighbors are
detected as down.
• both – Raises the power to max and open all rates.
• none – No action taken.
• open-rates – Opens all rates.
• raise-power – Raises the power to maximum.
• radio [<1-4096>|<radio-list>] – Modifies the action for
specified radio(s).
• <1-4096> – Sets a single radio index.
• <radio-list> – Defines a list (1,3,7) or range (3-7) of
radio indices.
enable Monitors access points and attempts to increase coverage on a
detected failure.
neighbors <1-4096>
[<1-4096>|<radio-index>]
Adds a radio as a neighbor.
• <1-4096> – Sets a single radio index.
• <radio-list> – Defines a list (1,3,7) or range (3-7) of
radio indices.
run-neighbor-detect Disassociates all wireless clients, clears current neighbors and
runs neighbor detection again.