Filter
Top Products
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 617
53-1001931-01
Wireless configuration commands
20
convert-ap
Wireless configuration commands
Changes the mode of operation of an AP to either sensor or standalone
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
NOTE
The number of APs supported by convert-ap command differs for each controller.
- Mobility RFS7000 Controller supports <1-256> APs
- Mobility RFS6000 Controller supports <1-64> APs
- Mobility RFS4000 Controller supports <1-6> APs
convert-ap
<
ap-index
>
[default|sensor|standalone]
convert-ap <ap-index> [default|standalone]
convert-ap <ap-index> sensor
{static-ip <IP/Mask>
{<gateway-IP>}}
Parameters
Example
RFController(config-wireless)#convert-ap 1 default
Converting an AP to sensor
To convert a BR300 to a sensor:
<ap-index>
[default|sensor|
standalone]
Sets the indices of the APs to be converted.
• <ap-index> – The index of the AP to be converted. This index
can be found from the 'show wireless ap' command.
• default – Does not force conversion. Lets the AP negotiate its
normal mode of operation with the controller.
• sensor {static-ip <IP/Mask> {<gateway-IP>}}– Converts an
BR300 to operate as an IPS (Intrusion Prevention System)
sensor.
• static-ip <IP/Mask> – Optional. Sensor must use
specific static IP address.
• <IP/Mask> – Sensor IP address and network
mask.
• <gateway-IP> – Optional. Specify gateway IP address for
sensors
NOTE: The controller will not be able to adopt this AP again until it
is converted back to a BR300 using the
sensor
<1-256> revert-to-ap
command
NOTE: The controller will not be able to adopt this AP again until
the AP is converted back to a thin-AP using the AP’s
configuration interface.